Ordinary Release Bearing VKC3592
The DUHUI VKC3592 ordinary release bearing is a direct replacement engineered for MITSUBISHI, HYUNDAI, and KIA applications. This release bearing matches OE specification MD703270 and cross-references with SKF VKC3592, LUK 500030460, and SACHS 3151831001.
Specifications
| Parameter | Value |
|---|---|
| DH Code | |
| Part Number | VKC3592 |
| Inside Diameter | 35.00 mm (1.378 inch) |
| Outside Diameter | 62.00 mm (2.441 inch) |
| Width | 18.00 mm (0.709 inch) |
| Warranty | 2 years / 50,000 km |
| Type | Push-type |
Important: All information on this page is for reference only. Please verify OE numbers, dimensions, and vehicle fitment against your original part before ordering. Contact us for fitment confirmation.
DH Code & OE Numbers & Reference Numbers
DH Code:
OE Numbers: MD703270
Reference Numbers (Interchange):
SKF: VKC3592
Timken: RCTS324SA, 55TKA3201, FCR55-1/2E, 614016, RB9861, RB9974, BRG350, CB2081C
LUK: 500030460
SACHS: 3151831001
Vehicle Fitment
MITSUBISHI: DELICA / SPACE GEAR 2.0 (PA3V) 1995-2002, GALANT IV (A16_) 2.0 GLS (A163) 1980-1984, L 300 / DELICA II Bus (LO3_P/G, L0_2P) 2.0 4WD (L037G) 1986-1987
HYUNDAI: Various models
KIA: Various models
Please verify OE number, dimensions and vehicle configuration before ordering.
Product Features
- 35 mm inside diameter and 62 mm outside diameter match MITSUBISHI, HYUNDAI, and KIA clutch system specifications.
- OE-match design for DELICA, GALANT, and L 300 applications.
- Push-type release bearing configuration compatible with original clutch systems.
- Cross-references with SKF VKC3592, LUK 500030460, and SACHS 3151831001.
- Multiple interchange numbers including RCTS324SA, 55TKA3201, and FCR55-1/2E.
- Factory pre-lubricated with high-temperature grease for immediate installation.
Installation Notes
- Inspect the clutch fork and pivot ball for wear before installing the new release bearing.
- Clean the input shaft sleeve thoroughly and check for scoring or burrs that could damage the bearing.
- Apply a light coat of high-temperature grease to the sleeve contact surface – avoid over-greasing.
- Torque the retaining bolts to MITSUBISHI, HYUNDAI, or KIA factory specifications for secure attachment.
- Confirm clutch slave cylinder pushrod travel is within factory range to avoid over-travel.
About DUHUI Bearing
Manufactured by DUHUI Bearing – an automotive bearing supplier established in Zhejiang, China, in 2003. DUHUI produces release bearings to OE specifications. Contact us
