62/28-2RS/C3 Wheel Bearing For NISSAN
The DUHUI Bearing 62/28-2RS/C3 is a single-row deep groove ball bearing designed for automotive applications requiring low friction, high-speed capability, and reliable sealing. With a 28 mm bore, 58 mm outer diameter, and 16 mm width, this bearing features contact seals on both sides to prevent contamination and retain lubrication. It matches Nissan OE specification 38130CA000, where it is used as a differential pinion bearing in rear axle applications, and is cross-referenced with Koyo 62/28 2RS C3 and NSK 62/28.LLU.C3 equivalents.
Technical Specifications
| Specification | Value / Detail |
|---|---|
| DH Code | DWB2596 |
| Part Number | 62/28-2RS/C3 |
| Product Type | Deep Groove Ball Bearing – Sealed, Single Row |
| Bore Diameter (d) | 28.00 mm (1.102 inch) |
| Outer Diameter (D) | 58.00 mm (2.283 inch) |
| Width (B) | 16.00 mm (0.630 inch) |
| Enclosure | 2RS – Rubber Seals on Both Sides |
| Radial Internal Clearance | C3 (Greater than Normal) |
| Material | High Carbon Chrome Steel (GCr15) |
| Weight | 0.17 kg (0.38 lb) |
Note: Dimensional data is based on Koyo and manufacturer published specifications. Please verify measurements against your original bearing before ordering.
Important: All information on this page is for reference only. Please verify OE numbers, dimensions, and vehicle fitment against your original part before ordering. Contact us for fitment confirmation.
DH Code & OE Numbers & Reference Numbers
DH Code: DWB2596
OE Numbers:
38130CA000
Reference Numbers (Interchange):
Koyo: 62/28 2RS C3
NSK: 62/28.LLU.C3
NTN: 62/28LLU
FAG: 62/28.2RSR.C3
Vehicle Fitment
This bearing is specified as a differential pinion bearing for the following Nissan models:
NISSAN MURANO: 2003-2014 (Rear Differential Pinion)
NISSAN ROGUE: 2008-2013 (Rear Differential Pinion)
Please verify OE number, dimensions and vehicle configuration before ordering.
Product Features
- Deep groove ball design accommodates radial loads and moderate axial loads in both directions – suitable for automotive differential pinion applications.
- 2RS contact seals on both sides provide effective contamination protection – retains lubricant and excludes dirt and moisture.
- C3 radial internal clearance accommodates thermal expansion in higher-temperature operating conditions and high-speed applications.
- Metric configuration with 28 mm bore and 58 mm outer diameter matches Nissan OE 38130CA000 and Koyo equivalents for direct replacement.
- Heat-treated bearing steel with precision-ground raceways – low friction coefficient and high limiting speed, with operating temperature range up to 120 °C.
Installation Notes
- Confirm bore diameter (28.00 mm) and outer diameter (58.00 mm) match your housing and shaft before installation.
- This is a sealed bearing – do not wash or re-lubricate before installation as the factory-fill grease is pre-installed.
- Inspect the shaft and housing for wear or damage – replace if scoring or pitting is present.
- Press the bearing squarely into the housing or onto the shaft – never apply force directly through the rolling elements.
- Torque all fasteners to vehicle manufacturer specifications.
About DUHUI Bearing
Manufactured by DUHUI Bearing – an automotive bearing supplier established in Zhejiang, China, in 2003. DUHUI produces deep groove ball bearings and automotive components to OE specifications. Contact us
