3550070-U02 Rear Wheel Hub Assembly for CHANGAN Eado OLD MODEL
DUHUI Bearing supplies 3550070-U02, a rear wheel hub assembly for the CHANGAN Eado OLD MODEL. The unit is an integrated, sealed and pre-lubricated hub and bearing assembly with a double-row bearing structure. ABS configuration varies by application, and the encoder type must be matched to the vehicle.
3550070-U02 Wheel Hub Assembly Specifications
| Specification | Value / Detail |
|---|---|
| DH Code | |
| Product Type | Rear wheel hub bearing unit / wheel hub assembly |
| Installation Position | Rear axle |
| Structure / Configuration | Integrated hub and bearing assembly; sealed and pre-lubricated |
| Bearing Form | Double-row load-bearing structure for radial and bidirectional axial loads |
| Set Contents | One complete hub bearing assembly; no confirmed axle nut, snap ring, mounting bolts or separate ABS sensor |
| ABS Configuration | Application-dependent; confirm magnetic encoder ring and sensor compatibility by VIN/EPC |
Important notice: Before ordering, confirm 3550070-U02 by VIN in the CHANGAN EPC and compare the old part: complete OE number, flange diameter, mounting hole spacing, hub stud count, ABS encoder or plug type, and side.
DH Code & OE Reference Numbers
DH Code:
OE Numbers:
CHANGAN: 3550070-U02.
Reference Numbers:
DAC2F70R4535B.
EBH3484.
3502150-U01.
15009023.
3550070-U01.
3502140-U01.
RM930237.
WH310636.
Vehicle Fitment
3550070-U02 fits the CHANGAN Eado OLD MODEL at the rear axle. This is the confirmed application for 3550070-U02. Certain CHANGAN CS35 and CHANGAN Eado XT applications may also use this number; confirm the model year, engine, drive type, axle, side and ABS configuration by VIN and EPC before ordering. Do not extend fitment to other CHANGAN models without that confirmation.
Product Features
3550070-U02 is an integrated wheel hub and bearing assembly. It combines the hub flange, bearing and seal in a unit that can be replaced as a complete assembly rather than a bare press-fit bearing.
The unit is sealed and pre-lubricated, and its double-row bearing structure is intended to carry radial and bidirectional axial loads. ABS configuration is application-dependent.
Ordering Verification
Order on the CHANGAN Eado OLD MODEL application; the CHANGAN CS35 and Eado XT entries remain unconfirmed, so obtain the VIN-based EPC entry for those vehicles before dispatch.
Installation Notes
These are general hub-unit principles, not CHANGAN repair-manual torque or procedure. Do not disassemble, separate or re-lubricate the sealed unit; use pullers, presses and support sleeves, and never hammer the bearing or hub flange. Clean the mounting faces, replace one-time fasteners as required, and use the CHANGAN torque data for the VIN with a calibrated torque wrench.
Procurement And Supply Information
3550070-U02 is supplied as one complete wheel hub assembly. Packaging and logistics data are estimates only; confirm the packing quantity, carton dimensions and included parts on the purchase order. Ask the supplier to confirm in writing the applicable CHANGAN model, year and ABS encoder type by VIN or EPC.
Quality And Compliance
Quality and compliance claims for this wheel hub assembly should be supported by documents for the exact product and batch. Before bulk purchase, request the quality-system certificate with number, issuer, validity, production address and scope, a product-level inspection report showing 3550070-U02 and the batch, and written warranty terms.
