62/22LU Wheel Bearing
The DUHUI Bearing 62/22LU is a single-row deep groove ball bearing with a 22 mm bore, 50 mm outer diameter, and 14 mm width. This sealed bearing features a contact seal on both sides (LU designation) for effective contamination protection, and is designed for automotive and industrial applications requiring low friction and high-speed capability. It matches OE specification 62/22LU and is cross-referenced with SKF, NTN, and NSK equivalents.
Technical Specifications
| Specification | Value / Detail |
|---|---|
| DH Code | DWB2424 |
| Part Number | 62/22LU |
| Product Type | Deep Groove Ball Bearing – Sealed, Single Row |
| Bore Diameter (d) | 22.00 mm (0.866 inch) |
| Outer Diameter (D) | 50.00 mm (1.969 inch) |
| Width (B) | 14.00 mm (0.551 inch) |
| Enclosure | LU – Rubber Seals on Both Sides |
| Material | High Carbon Chrome Steel (GCr15) |
Note: Dimensional data is based on manufacturer published specifications. Please verify measurements against your original bearing before ordering.
Important: All information on this page is for reference only. Please verify OE numbers, dimensions, and vehicle fitment against your original part before ordering. Contact us for fitment confirmation.
DH Code & OE Numbers & Reference Numbers
DH Code: DWB2424
OE Numbers:
62/22LU
Reference Numbers (Interchange):
SKF: 62/22-2RS1
NTN: 62/22LLU
NSK: 62/22DDU
Vehicle Fitment
This bearing is used in various automotive alternator, pulley, and accessory drive applications. Please verify OE number and dimensions before ordering.
Please verify OE number, dimensions and vehicle configuration before ordering.
Product Features
- Deep groove ball design accommodates radial loads and moderate axial loads in both directions – suitable for automotive alternator, pulley, and accessory drive applications.
- LU contact seals on both sides provide effective contamination protection – retains lubricant and excludes dirt and moisture.
- Metric configuration with 22 mm bore and 50 mm outer diameter matches OE 62/22LU for direct replacement.
- Heat-treated GCr15 bearing steel with precision-ground raceways – low friction coefficient and high limiting speed.
- Factory pre-lubricated – no additional greasing required before installation.
Installation Notes
- Confirm bore diameter (22.00 mm) and outer diameter (50.00 mm) match your housing and shaft before installation.
- This is a sealed bearing – do not wash or re-lubricate before installation as the factory-fill grease is pre-installed.
- Inspect the shaft and housing for wear or damage – replace if scoring or pitting is present.
- Press the bearing squarely into the housing or onto the shaft – never apply force directly through the rolling elements.
- Torque all fasteners to vehicle manufacturer specifications.
About DUHUI Bearing
Manufactured by DUHUI Bearing – an automotive bearing supplier established in Zhejiang, China, in 2003. DUHUI produces ball bearings and automotive components to OE specifications. Contact us
