62/28NRC3 Wheel Bearing For Toyota
The DUHUI Bearing 62/28NRC3 is a single-row deep groove ball bearing designed for automotive and industrial applications. With a 28 mm bore, 58 mm outer diameter, and 16 mm width, this sealed bearing features a non-contact seal on one side (NR) and a C3 radial internal clearance for higher-temperature operating conditions. It matches OE specification 62/28NRC3 and is cross-referenced with SKF, NTN, and NSK equivalents.
Technical Specifications
| Specification | Value / Detail |
|---|---|
| DH Code | DWB3562 |
| Part Number | 62/28NRC3 |
| Product Type | Deep Groove Ball Bearing – Sealed, Single Row |
| Bore Diameter (d) | 28.00 mm (1.102 inch) |
| Outer Diameter (D) | 58.00 mm (2.283 inch) |
| Width (B) | 16.00 mm (0.630 inch) |
| Enclosure | NR – Non-Contact Seal on One Side |
| Radial Internal Clearance | C3 (Greater than Normal) |
| Material | High Carbon Chrome Steel (GCr15) |
Note: Dimensional data is based on manufacturer published specifications. Please verify measurements against your original bearing before ordering.
Important: All information on this page is for reference only. Please verify OE numbers, dimensions, and vehicle fitment against your original part before ordering. Contact us for fitment confirmation.
DH Code & OE Numbers & Reference Numbers
DH Code: DWB3562
OE Numbers:
62/28NRC3
Reference Numbers (Interchange):
SKF: 62/28NRC3
NTN: 62/28NRC3
NSK: 62/28NRC3
Vehicle Fitment
TOYOTA: Various models (verify OE number and dimensions before ordering)
Please verify OE number, dimensions and vehicle configuration before ordering.
Product Features
- Deep groove ball design accommodates radial loads and moderate axial loads in both directions – suitable for automotive and industrial applications.
- Non-contact seal on one side (NR) provides contamination protection while minimizing friction – retains lubricant and excludes dirt and moisture.
- C3 radial internal clearance accommodates thermal expansion in higher-temperature operating conditions and high-speed applications.
- Metric configuration with 28 mm bore and 58 mm outer diameter matches OE 62/28NRC3 for direct replacement.
- Heat-treated GCr15 bearing steel with precision-ground raceways – low friction coefficient and high limiting speed.
- Factory pre-lubricated – no additional greasing required before installation.
Installation Notes
- Confirm bore diameter (28.00 mm) and outer diameter (58.00 mm) match your housing and shaft before installation.
- This bearing features a non-contact seal on one side – ensure the seal side is correctly oriented during installation.
- Inspect the shaft and housing for wear or damage – replace if scoring or pitting is present.
- Press the bearing squarely into the housing or onto the shaft – never apply force directly through the rolling elements.
- Torque all fasteners to vehicle manufacturer specifications.
About DUHUI Bearing
Manufactured by DUHUI Bearing – an automotive bearing supplier established in Zhejiang, China, in 2003. DUHUI produces deep groove ball bearings and automotive components to OE specifications. Contact us
