6901-2RS Wheel Bearing For Toyota
The DUHUI Bearing 6901-2RS is a single-row deep groove ball bearing with a 12 mm bore, 24 mm outer diameter, and 6 mm width. This sealed bearing features contact seals on both sides for effective contamination protection, and is designed for automotive and industrial applications requiring low friction and compact dimensions. It matches OE specification 6901-2RS and is cross-referenced with SKF, NTN, and NSK equivalents.
Technical Specifications
| Specification | Value / Detail |
|---|---|
| DH Code | DWB3529 |
| Part Number | 6901-2RS |
| Product Type | Deep Groove Ball Bearing – Sealed, Single Row |
| Bore Diameter (d) | 12.00 mm (0.472 inch) |
| Outer Diameter (D) | 24.00 mm (0.945 inch) |
| Width (B) | 6.00 mm (0.236 inch) |
| Enclosure | 2RS – Rubber Seals on Both Sides |
| Material | High Carbon Chrome Steel (GCr15) |
Note: Dimensional data is based on manufacturer published specifications. Please verify measurements against your original bearing before ordering.
Important: All information on this page is for reference only. Please verify OE numbers, dimensions, and vehicle fitment against your original part before ordering. Contact us for fitment confirmation.
DH Code & OE Numbers & Reference Numbers
DH Code: DWB3529
OE Numbers:
6901-2RS
Reference Numbers (Interchange):
SKF: 6901-2RS1
NTN: 6901LLU
NSK: 6901DDU
Vehicle Fitment
TOYOTA CARINA I (TA1_): 1.6 (TA12_, TA14_, TA12, TA14) 1970-1978
Please verify OE number, dimensions and vehicle configuration before ordering.
Product Features
- Deep groove ball design accommodates radial loads and moderate axial loads in both directions – suitable for automotive and industrial applications.
- 2RS contact seals on both sides provide effective contamination protection – retains lubricant and excludes dirt and moisture.
- Compact metric configuration with 12 mm bore and 24 mm outer diameter matches OE 6901-2RS for direct replacement.
- Heat-treated GCr15 bearing steel with precision-ground raceways – low friction coefficient and high limiting speed.
- Factory pre-lubricated – no additional greasing required before installation.
Installation Notes
- Confirm bore diameter (12.00 mm) and outer diameter (24.00 mm) match your housing and shaft before installation.
- This is a sealed bearing – do not wash or re-lubricate before installation as the factory-fill grease is pre-installed.
- Inspect the shaft and housing for wear or damage – replace if scoring or pitting is present.
- Press the bearing squarely into the housing or onto the shaft – never apply force directly through the rolling elements.
- Torque all fasteners to vehicle manufacturer specifications.
About DUHUI Bearing
Manufactured by DUHUI Bearing – an automotive bearing supplier established in Zhejiang, China, in 2003. DUHUI produces deep groove ball bearings and automotive components to OE specifications. Contact us
