160132RS Wheel Bearing
The DUHUI Bearing 160132RS is a single-row deep groove ball bearing with a 65 mm bore, 100 mm outer diameter, and 11 mm width. This automotive wheel bearing features rubber seals on both sides and matches OE specification 160132RS. It serves as a direct replacement for workshops, distributors, and B2B buyers requiring a reliable bearing solution.
Technical Specifications
| Specification | Value / Detail |
|---|---|
| DH Code | |
| Part Number | 160132RS |
| Product Type | Single Row Deep Groove Ball Bearing |
| Bore Diameter (d) | 65.00 mm (2.559 inch) |
| Outer Diameter (D) | 100.00 mm (3.937 inch) |
| Width (B) | 11.00 mm (0.433 inch) |
| Seals | 2RS – Rubber Seals Both Sides |
| Cage Material | Steel Cage |
| Weight | 0.28 – 0.30 kg |
Note: Dimensional data is based on manufacturer published specifications. Please verify measurements against your original bearing before ordering.
Important: All information on this page is for reference only. Please verify OE numbers, dimensions, and vehicle fitment against your original part before ordering. Contact us for fitment confirmation.
DH Code & OE Numbers & Reference Numbers
DH Code:
OE Numbers:
160132RS
Reference Numbers (Interchange):
16013-2RS, 16013.2RS, 7000113.2RS, 60132RS1, 6013-2RS, 6013LLU
Vehicle Fitment
Please verify OE number, dimensions and vehicle configuration before ordering. Fitment data is not available for this part number.
Product Features
- Single-row deep groove ball bearing design supports radial loads and moderate axial loads in both directions.
- 2RS rubber seals on both sides protect against dust and moisture ingress, extending service life.
- Steel cage construction provides reliable roller guidance and durability under load.
- Pre-lubricated and maintenance-free – ready to install upon arrival.
- Precision-ground raceways and heat-treated components ensure consistent performance.
- Available for product customization – logo, code, pattern, or words can be applied to the bearing or packaging.
Installation Notes
- Confirm bore diameter (65.00 mm) and outer diameter (100.00 mm) match your housing and shaft before installation.
- This is a single-row deep groove ball bearing – verify your application requires this configuration.
- Inspect the housing and shaft surfaces for wear or damage before installing new components.
- Apply even pressure when pressing the bearing into the housing or onto the shaft – never apply force directly through the rolling elements.
- Bearing is pre-lubricated and sealed – no additional greasing required before installation.
About DUHUI Bearing
Manufactured by DUHUI Bearing – an automotive bearing supplier established in Zhejiang, China, in 2003. DUHUI produces wheel bearings and automotive components to OE specifications. Contact us
